Table of Contents
Advertisement
The PELH30A has an own self-cleaning mechanism of the grate. When the thermostat reaches the
adjusted off-temperature, the burn-out cycle begins and afterwards, the grate moves out to be
cleaned by scraping. This enables longer time of use, without need to remove the burner from the
boiler. The amount of pellets which can be combusted before the ash is removed, is determined by
the size of the boiler´s ashtray. The burner is equipped with the control system that regulates gear of
the ash removing feeder.
Convectional parts of the boiler have to be cleaned in regular intervals to keep the high efficiency of
heating.
The PELH30A is intended for combustion of the wood pellets with diameter of 6-10 mm.
The burner PELH30A is made in conformity with the industrial norms and prescriptions and it was
tested and approved in conformity with the directives about the low voltage appliances as well as
with the directives about the electromagnetic interference.
Dimensions / Contents of delivery
The PELH30A is delivered in a paper box filled with polysthyrene to improve stability. If the box is
damaged, check the burner for possible damage by transport. Claim of the damage by transport has
to be registered by a spediteur.
The paper box ought contain the following items:
1 pc. Burner PELH30A
1 pc. Inlet tube with emergency thermostat of back-burning
1 pc. External temperature sensor for the boiler temperature
4
Advertisement
Table of Contents
