Record Schedule Configuration - Speco NRP Series User Manual

Record & Disk Management

Set Day Schedule
Click and then drag the cursor on the time scale to set record time; click
selected area.
You can manually set the record start time and end time. Click
below. Set the start and end time in the window and then click "OK" to save the settings.
Click "All" to set all day recording; click "Reverse" to swap the selected and unselected time in a day; click "Clear All" to clear all the selected area in
a day.
Click "Copy To" to copy the schedule of the day to other days. Refer to the picture below. Check the days in the window and then click "OK" to save
the settings.

Set Week Schedule
Click or and then click "Manual" beside
the days in the window and then click "OK" to save the settings.
Click "All" to set all week recording; click "Reverse" to swap the selected and unselected time in a week; click "Clear All" to clear all the selected
area in a week.

7.3.2 Record Schedule Configuration

Click StartSettingsRecordRecord ScheduleSchedule Configuration to go to the interface as shown below. Set the schedule of sensor record,
motion record, timed record and intelligence record. Click "None" in the drop-down menu to clear the schedule. Click "Apply" to save the settings.
and then drag the cursor on the time scale to delete the
or and then click "Manual" on each day to pop up a window as shown
to set the week schedule. Refer to the picture below. Set the start and end time, check
31
NVR User Manual