Device Management; Network Configuration; Tcp/Ip Configuration; Port Configuration - Speco NRP Series User Manual

Device Management

11.1 Network Configuration

11.1.1 TCP/IP Configuration

Click StartSettingsNetworkTCP/IP to go to the following interface. Check "Obtain an IPv4 address automatically", "Obtain an IPv6 address
automatically" and "Obtain DNS automatically" to get the network addresses automatically, or manually enter the network addresses. You can
modify the MTU value according to the network condition (MTU, Maximum Transmission Unit, can be modified according to network condition for
higher network transmission efficiency). Click "Apply" to save the settings.
Note:
 Internal Ethernet Port
If you use the NVR with the PoE network ports, click "Internal Ethernet Port" to go to the following interface.
The internal ethernet port is the port which connects all the PoE ports with the NVR system. The PoE ports are available if the internal ethernet
port is online; if it is offline, all the PoE ports will be unavailable, may be the internal ethernet port is broken. The network addresses of the internal
ethernet port can be changed to make the port in the same network segment with the IP cameras which directly connect to the PoE ports of the
NVR (it is not recommended to change the network addresses of the internal ethernet port).

11.1.2 Port Configuration

Click StartSettingsNetworkPort to go to the interface as shown below. Enter the HTTP port, HTTPS port, server port and RTSP port of the
NVR, enable "Anonymous" as needed and then click "Apply" button to save the settings.
HTTP Port: the default HTTP port of the NVR is 80. The port number can be changed to others like 81. The port is mainly used to IE remote access.
If you want to access the NVR through IE, you should enter IP address plus HTTP port in the IE address bar like http://192.168.11.61:81.
HTTPS Port: the default HTTP port of the NVR is 443.
Server Port: the default server port of the NVR is 6036. The server port number can be changed as required. The port is mainly used in network
video management system.
RTSP Port: RTSP real-time stream protocol can be used to control the sending of real-time data. By media player which supports the RTSP real-time
11 Device Management
55
NVR User Manual