Connecting To The Computer - Roland VersaUV LEF2-200 Setup Manual

Connecting to the Computer

Introduction
Make sure the machine is connected to the network by an Ethernet cable.
The network settings on the machine must be made manually, using the operation panel. For infor-
mation about how to make the settings, refer to "Step 2: Make the Network Settings on the Printer"
(P.39) later in this step.
Also, to perform printing from this machine, the software RIP included with the machine must be
installed on the computer you are using. For information about installation and setup, refer to the
documentation for the software RIP.
This machine has a built-in print server as a network interface. When you use the print server, you
can send print data to the machine from anywhere on the network. TCP/IP is used as the protocol.
IM P O RTA NT
The examples used in the procedures for making the settings described in this section assume you
are using one computer and one machine. The procedures and setting values described here may
not be suitable for all operating environments.
If the computer you are using is connected to a number of networked devices or to the Internet, in-
correct settings may adversely affect the entire network. For detailed information about the settings,
consult your network administrator.
2.Installation
35