Keithley 2001-TCSCAN Instruction Manual page 37

Operation
Table 3-1 cont.
Summary of SCPI commands (Models 2001 and 2002)
Command
TRACe command summary
:TRACe
:POINts <n>
:AUTO <b>
:FEED <name>
:CONTrol <name>
:DATA?
Trigger command summary
:INITiate
[:IMMediate]
:CONTinuous <b>
:TRIGger
:COUNt <n>
:SOURce <name>
:TIMer <n>
UNITs command summary
:UNIT
:TEMPerature <name>
NOTE: The SCAN:INTernal <function> parameter (ROUTe command summary) is one of the following:
VOLTage:DC
VOLTage:AC
TEMPerature
FREQuency
RESistance
FRESistance
RJUNctionX
NONE
ALTernate[1]
3-8
Description
Commands to configure buffer:
Specify buffer size.
Enable or disable auto buffer sizing (uses :trigger:count).
Select source of readings (SENSe[1], CALCulate [1], NONE).
Select buffer control mode (NEVer, NEXT, ALWays).
Read all readings in the buffer.
Initiation commands:
Initiate one trigger cycle.
Enable or disable continuous initiation.
Trigger layer commands:
Specify total number of channels to scan (1 to 99999).
Select control source (IMMediate, TIMer, MANual).
Set timer interval (0 to 999999.999 seconds).
Command to select temperature units:
Select temperature measurement units (C, CEL, F, FAR, K).
DC volts
AC volts
Temperature
Frequency
2-wire ohms
4-wire ohms
Reference junction (X = 1 to 5)
No function (skips listed channel during scan).
Alternate function.