Assist" Menu - Grundfos MAGNA3 25-80 Installation And Operating Instructions Manual

"Display brightness"
Navigation
"Home" > "Settings" > "General settings" > "Display brightness"
Setting
1. Press [OK].
2. Set brightness with and
3. Press [OK] to save.
"Return to factory settings"
Navigation
"Home" > "Settings" > "General settings" > "Return to factory
settings"
Setting
To overwrite the current settings with the factory settings, select
"Yes" with or and press [OK].
You can recall the factory settings and overwrite the current
settings. All user settings in the "Settings" and "Assist" menus are
set back to the factory settings. This also includes language,
units, setup of analog input, multipump function, etc.
"Run start-up guide"
Navigation
"Home" > "Settings" > "General settings" > "Run start-up guide"
Setting
To run the startup guide, select "Yes" with
[OK].
The startup guide automatically starts when you start the pump
for the first time; however, you can always run the startup guide
later via this menu.
The startup guide guides you through the general settings of the
pump, such as language, date and time.
48
.
or and press

8.8 "Assist" menu

Navigation
"Home" > "Assist"
Press and go to the "Assist" menu with
The menu guides you through and offers the following:
• Application wizard (available for pumps with production code
from 1838)
• Setting of date and time
• Multipump setup
• Setup, analog input
• Description of control mode
• Assisted fault advice.
The "Assist" menu guides the user through the setting of the
pump. In each submenu, there is a guide that guides the user
through the setting of the pump.
8.8.1 "Application wizard"
Available for pumps with production code from 1838.
Navigation
"Home" > "Assist" > "Application wizard"
This menu guides you through a complete pump setup and helps
you set the correct control mode.
Applications available in this menu:
• Boiler pump
• Radiator
• Fan coil unit
• Air handling unit
• Underfloor/ceiling
• Hot water
• Ground source
• Chiller pump.
Setting
1. Choose the system that applies to the function of your pump
with or and press [OK] followed by
2. Select the characteristics applicable to your system with
and press [OK] followed by
3. Continue this process until the setup has been completed.
If you wish to change the selected control mode, either launch the
"Application wizard" again or choose a control mode in the
"Settings" menu. See section 8.7.3 "Control
.
.
or
.
mode".