Flush; Dryer - Grohe Sensia ARENA 39355SH0 User Manual

Flush

The Toilet Does Not Flush Automatically
[AUTO FLUSH] is set to [OFF].
 Set the [AUTO FLUSH] to other than [OFF].
The toilet bowl is clogged.
 All functions stops when the water level within the toilet bowl reaches the point where the water will overflow.
Remove the clog of the toilet bowl.
Water Flow Is Weak or the Toilet Is Not Flushed Completely
Too much toilet paper is used.
 When too much toilet paper is used, it may not be flushed completely when the
this case, press the
 Please note that the amount of toilet paper that can be flushed in a single full flush is approximately 5 m.
Toilet Bowl Is Clogged
Too much toilet paper is used.
 Set the [AUTO FLUSH] to [OFF], then unclog the toilet.
*Toilet may flush automatically during unclogging, and the water inside the toilet bowl may overflow.
Water Is Running in the Toilet Bowl
[INTERMITTENT FLUSH] is set to [ON].
 This is not a problem. Water runs every 6 minutes when [INTERMITTENT FLUSH] is set to [ON].
Flushing Starts When Sitting on the Toilet Seat
 This is not a problem. The pre-wash function is working. When the user sits on the toilet seat, the toilet bowl
becomes wet with a small amount of water to prevent it from getting dirty.

Dryer

The Dryer Does Not Work
The seating sensor does not detect a user.
 Sit on the toilet seat. Or change your sitting posture. For example, sit further back on the seat.
 Allow the sensor to detect the skin of a user.
 If the seating sensor is dirty or water drops have adhered to the seating sensor, clean the seating sensor.
(Page
(flush/full) button.
19)
(Page 19)
60
Troubleshooting
(flush/light) button is used. In
(Page 40)