Configuring Hybrid Insertion Based On L3+ Spus; Configuring Mpls Service Redirection At Public Network Side - H3C S9500 Series Operation Manual

Operation Manual – MPLS Hybrid Insertion
H3C S9500 Series Routing Switches
Configure the traffic
redirection action for the
traffic behavior
Enter QoS policy view
Configure the QoS policy
Apply QoS policy to the
port
Note:
Configure the port-based QoS policy only in the case of L3VPN hybrid insertion.
You can add multiple ports to an MPLS loopback group for load sharing purpose.
LSB1GV48DA0, LSB1GV48DB0, and LSB1XP4DB0 do not support L2VPN hybrid
insertion.

1.3 Configuring Hybrid Insertion Based on L3+ SPUs

Before configuring the hybrid insertion based on L3+ SPUs, you need to:
Redirect the MPLS and VPLS services at the public network side to the virtual
service interface on the L3+ board for processing.
Bind the VPLS instance with different MPLS-VPLS virtual service interfaces to
share the load of VPLS service.
In the configuration of hybrid insertion based on L3+ SPUs, two types of virtual service
interface on the L3+ board are used:
MPLS virtual service interface
MPLS-VPLS virtual service interface

1.3.1 Configuring MPLS Service Redirection at Public Network Side

MPLS service redirection is to redirect the MPLS service to the MPLS virtual service
interface on the L3+ board capable of MPLS processing.
To do...
redirect { cpu | interface
interface-type interface-number |
next-hop { ipv4-add [ ipv4-add ] |
ipv6-add [ interface-type
interface-number ] [ ipv6-add
[ interface-type interface-number |
link-aggregation group
group-number ] ] } }
qos policy policy-name
classifier tcl-name behavior
behavior-name
qos apply policy policy-name
{ inbound | outbound }
Chapter 1 MPLS Hybrid Insertion Configuration
Use the command...
1-4
Remarks
Required
Required
Required
Required