Example For Configuring L3+ Hybrid Insertion - H3C S9500 Series Operation Manual

Hide thumbs Also See for S9500 Series:

Table of Contents

Operation Manual – MPLS Hybrid Insertion

H3C S9500 Series Routing Switches

[PE2] link-aggregation

# Add multiple ports to the MPLS service loopback group.

[PE2] interface GigabitEthernet 2/2/3

[PE2-GigabitEthernet2/2/3] stp disable

[PE2-GigabitEthernet2/2/3] port link-aggregation group 1

[PE2-GigabitEthernet2/2/3] interface GigabitEthernet 2/2/4

[PE2-GigabitEthernet2/2/4] stp disable

[PE2-GigabitEthernet2/2/4] port link-aggregation group 1

# Bind the VPNA to the VLAN interface that connects PE 2 and CE 3.

[PE2] interface vlan-interface 10

[PE2-vlan-interface10] mpls l2vc 1.1.1.1 100

[PE2-vlan-interface10] quit

Note:

Currently, only MPLS boards with a suffix of CA or CB support VLL (L2VPN). Thus,

VLL hybrid insertion includes:

- Hybrid insertion of non-MPLS boards and MPLS boards with a suffix of CA

- Hybrid insertion of MPLS boards with a suffix of C and MPLS boards with a suffix of

All MPLS boards support MPLS L3VPN. Thus, L3VPN hybrid insertion refers to

hybrid insertion of non-MPLS boards and MPLS boards only.

You need to configure the port-based QoS policy for L3VPN hybrid insertion only,

but not for VLL hybrid insertion.

1.4.3 Example for Configuring L3+ Hybrid Insertion

I. Network requirements

Bind the VPLS virtual service interface with the VPLS instance.

Configure the backup virtual service interface.

Chapter 1 MPLS Hybrid Insertion Configuration

group 1 service-type mpls

1-17

Table of Contents