Operation Manual – IP Performance H3C S9500 Series Routing Switches Table of Contents Table of Contents Chapter 1 IP Performance Configuration..................1-1 1.1 IP Performance Overview....................1-1 1.2 Enabling Forwarding of Directed Broadcasts to a Directly Connected Network ....1-1 1.2.1 Enabling Forwarding of Directed Broadcasts to a Directly Connected Network (in...
Operation Manual – IP Performance H3C S9500 Series Routing Switches Chapter 1 IP Performance Configuration Chapter 1 IP Performance Configuration When configuring IP performance, go to these sections for information you are interested in: IP Performance Overview Enabling Forwarding of Directed Broadcasts to a Directly Connected Network...
H3C S9500 Series Routing Switches Chapter 1 IP Performance Configuration Note: S9500 series routing switches can still receive broadcasts from a designated UDP port even if they are disabled from receiving directed broadcasts. 1.2.1 Enabling Forwarding of Directed Broadcasts to a Directly Connected...
Operation Manual – IP Performance H3C S9500 Series Routing Switches Chapter 1 IP Performance Configuration 1.2.3 Configuration Example I. Network requirements As shown in Figure 1-1, the host’s interface and VLAN-interface 3 of Switch A are on the same network segment (1.1.1.0/24). VLAN-interface 2 of Switch A and VLAN-interface 2 of Switch B are on another network segment (2.2.2.0/24).
Operation Manual – IP Performance H3C S9500 Series Routing Switches Chapter 1 IP Performance Configuration After the above configurations, if you ping the subnet broadcast address (2.2.2.255) of VLAN-interface 2 of Switch A on the host, the ping packets can be received by VLAN-interface 2 of Switch B.
S9500 series routing switches will send ICMP redirect packets to the source host under the following conditions: The receiving and forwarding interfaces are the same...
Page 7
If the device received an IP packet with a timeout error, it drops the packet and sends an ICMP timeout packet to the source. S9500 series routing switches will send ICMP timeout packets under the following conditions: If the switch finds the destination of a packet is not itself and the TTL field of the packet is 1, it will send a “TTL timeout”...
Page 8
H3C S9500 Series Routing Switches Chapter 1 IP Performance Configuration Note: When performing hardware forwarding, S9500 series routing switches will not forward ICMP destination unreachable packets even if the above conditions are satisfied. II. Disadvantage of sending ICMP error packets...
Operation Manual – IP Performance H3C S9500 Series Routing Switches Chapter 1 IP Performance Configuration 1.6 Displaying and Maintaining IP Performance To do… Use the command… Remarks Display current TCP display tcp status connection state Display TCP connection display tcp statistics...