AuroraPresto—User Guide
Setting up the IP Ping Test
-1- From the Main Setup screen choose Ping.
Note
To access the Ping Setup screen from the Ping Test screen,
press F4 Setup.
-2- Select one of the following and press ENTER.
Note
The Mode option is only available if you have set the IP
Mode to Routed. See
IP Frame Setup—See
4-86
The Ping Setup screen is displayed.
Mode—Use to set up the network type. Choose
•
LAN if you are using an Ethernet connection.
Choose WAN if you are using an ADSL
connection.
Setting up the IP Mode
Dst—Use this to set up the Destination IP
•
Address. This consists of 4 groups of 3 digits.
The maximum number you can enter in each
group is 255.
Pings—Enter the number of Pings to be sent
•
between 0 to 10000 (0 = continuous).
Timeout (ms)—Enter a timeout length between
•
500 to 5000ms. This is the length of time
AuroraPresto
assumes that a reply will not be received.
Ping Length—Use this to set up a payload for
•
the Ping. Enter a ping length between 1 and
1000 bytes or characters.
Pause—Enter a time,
•
between each ping it sends, between 0 to
1000ms.
Setting up IP Framing
waits after sending a ping before it
AuroraPresto
on page 3-16.
waits
on page 3-21.
481801