Table of Contents
Advertisement
AuroraPresto—User Guide
The PAT option (also known as NAPT Network Port
Address Translation) is used when you want to connect to
several devices.
These options are only available if you have set up the IP
Mode to Routed.
-1- From the IP Setup screen select NAT and press
-2- Choose NAT or PAT depending on the connection.
Setting up the DHCP
(Dynamic Host Configuration Protocol)
This option is only available if you have set up the IP Mode
to Routed.
The DHCP option enables
as a Golden Router, to allocate IP addresses to the LAN
dynamically so that an address can be reused when a device
is no longer connected to the network.
The DHCP pool is the number of local IP addresses that the
server can distribute. The limit is 10 on
DHCP allocates a lease to each IP address. This lease can be
unlimited (Permanent), set for a length of time set up by
the user (Leased).
-1- Select DHCP Setup from the IP Setup screen to
3-24
ENTER to display the NAT options.
Choose Off to disable the NAT option.
display the DHCP Setup screen.
AuroraPresto
, when configured
AuroraPresto
.
481801
Advertisement
Table of Contents
