Table of Contents
Advertisement
-2- Select Threshold.
BER
The
currently selected number of errors occur within the
selected test time. The rate is shown as x.yE-z, where E-z
means 10 to the power of z. In the above example, the rate
is 1.0x109.
-1- If the following screen is displayed,
To set the threshold as a number of errors:
-1- Select Errors from the Threshold screen to display
-2- Enter a number of errors between 1 and 100 and press
Issue 7 - 05/02
display shows the error rate that applies if the
press F1 On to enable the threshold.
an entry window.
ENTER.
Section 5 - ATM Layer Tests
4-61
Advertisement
Table of Contents
