Before Using; How To Use As A Cake Pop Maker; Changing Cooking Plates; To Remove Cooking Plates - Babycakes MT-6 Instruction Manual

1) The marked electrical rating of the cord set or extension cord should be at least as
great as the electrical rating of the appliance, and
2) The cord should be arranged so that it will not drape over the countertop or tabletop
where it can be pulled on by children or tripped over unintentionally.
DO NOT OPERATE APPLIANCE IF THE LINE CORD SHOWS ANY DAMAGE, OR IF
APPLIANCE WORKS INTERMITTENTLY OR STOPS WORKING ENTIRELY.
IMPORTANT
During the first few minutes of initial use, you may notice smoke and/or a slight odor. This is
normal and should quickly disappear. It will not recur after appliance has been used a few
more times.
Solid surface countertops can be easily scratched, cracked, scorched, or damaged,
especially when exposed to heat. To prevent damage, the following precautions should be
observed when using this product:
• Always use a trivet under heat generating sources such as Slow Cookers, Toaster
Ovens, Skillets, Treat Makers, etc.
Carefully unpack the treat maker and all parts. Remove all packaging materials, including
any stickers or labels.
damp cloth or sponge. Wipe dry with a soft cloth. NEVER IMMERSE THE TREAT MAKER
OR CORD IN WATER OR ANY OTHER LIQUID. Position the treat maker on a dry, level,
heat-resistant surface. It is recommended to operate this appliance on a separate outlet
and circuit from other appliances to avoid overloading the circuit.

CHANGING COOKING PLATES

WARNING: Always unplug the unit and allow the unit to cool before removing or replacing
Cooking Plates.

TO REMOVE COOKING PLATES:

Locate the Cooking Plate Release Latches on both the lower and upper sections of the treat
maker. Remove either the lower or upper cooking plate first by firmly pushing on the release
latch. The Cooking Plate will release and pop up slightly. Using both hands, remove the
Cooking Plate. The second Cooking Plate should be removed in the same manner.
TO INSERT COOKING PLATES:
Align both Cooking Plates with the openings under the back hinges of the treat maker. Push
down on the Cooking Plate. This will snap the Cooking Plate into place. Ensure Cooking
Plates are securely attached before using.

HOW TO USE AS A CAKE POP MAKER

1. Position the treat maker on a dry, level, heat-resistant surface.
2. Release the lid latch and lift the lid to the open position.
3. Insert the cake pop plates according to instructions.
4. To maintain the quality of the nonstick it is recommended to periodically coat the nonstick
surface with a small amount of vegetable oil. This can be done with a paper towel or with
a nonstick oil spray. Wipe off any excess oil.
5. Plug the power cord into a 120V outlet, preferably on a separate outlet from other
appliances to prevent the circuit from being overloaded.
6. Lower the lid to the closed position and allow the treat maker to preheat for a few minutes.
When ready, the red POWER light will be illuminated.
TIP: Allow plenty of time to prepare ingredients for cake pops and make sure

BEFORE USING

Clean the interior and exterior surfaces of the treat maker with a
5