Displaying And Maintaining Mac-Based Vlan; Mac-Based Vlan Configuration Example - H3C S3100 Series Operation Manual

Operation Manual (For Soliton) – VLAN
H3C S3100 Series Ethernet Switches
Enable the MAC-based
VLAN function
Note:
You cannot enable MAC-based VLAN on a link aggregation group member port.
You cannot enable MAC-based VLAN on a port configured with VLAN-VPN or
selective QinQ.

2.3.2 Displaying and Maintaining MAC-Based VLAN

Display all interfaces with
MAC-based VLAN
enabled
Display MAC-to-VLAN
mappings

2.3.3 MAC-Based VLAN Configuration Example

I. Network requirements
As shown in
switch through a hub. Ports Ethernet 1/0/1 and Ethernet 1/0/2 on the switch are
connected to Server B in VLAN 100 and Server A in VLAN 200 respectively.
Configure the switch to allow Host B to access Server B and Host A to access Server A.
That is, packets sent from Host B can be transmitted in VLAN 100 and those sent from
Host A can be transmitted in VLAN 200.
To do...
mac-vlan enable
To do...
display mac-vlan
interface
display mac-vlan { all |
dynamic | static | vlan
vlan-id }
Figure 2-2, Host A and Host B are connected to port Ethernet 1/0/3 on the
Use the command...
Use the command...
2-9
Chapter 2 VLAN Configuration
Remarks
Required
Disabled by default.
Remarks
Available in any view.
Available in any view.