H3C S3100 Series Operation Manual page 23

Operation Manual (For Soliton) – VLAN
H3C S3100 Series Ethernet Switches
Caution:
At present, the S3100 series support only the standard templates of AppleTalk and
IP, the standard template of IPX encapsulated in Ethernet II format, and the
user-defined templates matching the Ethernet II encapsulation format. Protocol
templates matching 802.2/802.3 encapsulation formats and their extended
encapsulation formats are not supported on the S3100 series currently.
Because the IP protocol is closely associated with the ARP protocol, you are
recommended to configure the ARP protocol type when configuring the IP protocol
type and associate the two protocol types with the same port to avoid that ARP
packets and IP packets are not assigned to the same VLAN, which will cause IP
address resolution failure.
When you use the mode keyword to configure a user-defined protocol template, if
you set the etype-id argument for ethernetii packets to 0x0800, 0x8137, or 0x809B,
the matching packets will take the same format as that of the IP, IPX, and AppleTalk
packets respectively. To prevent two commands from processing packets of the
same protocol type in different ways, the switch will prompt that you cannot set the
etype-id argument for Ethernet II packets to 0x0800, 0x8137, or 0x809B.
2.4.3 Associating a Port with a Protocol-Based VLAN
I. Configuration prerequisites
The protocol template for the protocol-based VLAN is configured.
The port is configured as a hybrid port, and the port is configured to remove VLAN
tags when it forwards the packets of the protocol-based VLANs.
II. Configuration procedure
Follow these steps to associate a port with the protocol-based VLAN:
Enter system view
Enter port view
Associate the port with
the specified
protocol-based VLAN
To do...
system-view
interface interface-type
interface-number
port hybrid protocol-vlan
vlan vlan-id { protocol-index
[ to protocol-index-end ] | all }
Use the command...
2-12
Chapter 2 VLAN Configuration
Remarks
—
—
Required
By default, a port is not
associated with any
protocol-based VLAN.