Mechanical Installation; Important Notes; Transport; Preparation - Lenze MCM Series Mounting And Switch-On Instructions

Mechanical installation

Important notes

You must install the product according to specifications in the chapter "standard and
•
operating" conditions.
4Standards and operating conditions
The technical data and the data regarding the supply conditions can be found on the
•
nameplate and in this documentation.
Observe the information relating to the surface and corrosion protection.
•
Ambient media − especially chemically aggressive ones − may damage shaft sealing rings,
•
lacquers and plastics. If required, contact your responsible Lenze subsidiary.

Transport

Ensure appropriate handling.
•
Make sure that all component parts are safely mounted. Secure or remove loose
•
component parts.
Only use safely fixed transport aids (e.g. eye bolts or support plates).
•
Do not damage any components during the transport.
•
Avoid electrostatic discharge on electronic components and contacts.
•
Avoid impacts.
•
Check the carrying capacity of the hoists and load handling devices. The weights can be
•
obtained from the shipping documents.
Secure the load against tipping and falling down.
•
Standing under a suspended load is forbidden.
•

Preparation

Remove protection covers from the shafts
•
Remove corrosion protection from the shafts and contact surfaces (flange/foot)
•
If necessary, remove dirt using standard cleaning solvents
•
NOTICE
Material damage caused by solvents!
Solvents can destroy bearings and sealing rings.
▶ Bearings or sealing rings must not come into contact with the solvent!

Installation

Avoid resonances with the rotational frequency and double mains frequency.
•
The mounting surfaces must be plane, torsionally rigid and free from vibrations.
•
The mounting areas must be suited to absorb the forces and torques generated during
•
operation.
Ensure an unhindered ventilation.
•
For versions with a fan, keep a minimum distance of 10 % from the outside diameter of the
•
fan cover in intake direction.
^ 48
Mechanical installation
Installation
37