Door Handle Assembly; Tube Channel Assembly Replacement - Quadra-Fire 3100 Millennium Owner's Manual

31M-ACC-C
E. Door Handle Assembly
Service Part: 832-0540
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown in Figure 24.1.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam
over shaft
6. Install locknut but do not over tighten, the handle needs
to move smoothly.
7. Install spring handle turning in a counter-clockwise
motion to required 2 inch (51mm) clearance location
on door handle rod (Figure 24.1).
Door Cross Section
(example)
Latch Cam
Locknut
Spacing
Washers
Figure 24.1
CAUTION!
Do not over tighten lock nut. The door handle needs to
move smoothly.
Tube Channel Rack
Figure 24.2
24
2 inch (51mm) clearance
required from bend in door
handle rod to end of spring
handle.
Spring
Handle
Door Handle
Square Key
Slide one gasket
over each tube
F. Tube Channel Assembly Replacement
Service Part: SRV7033-023
Removing Tube Channel Assembly
1. Remove the right side shield by removing 2 screws in
the back using a Phillips head screw driver.
2. Remove 4 screws from channel access cover and
remove cover.
3. Locate 2 channel nuts inside of chamber and
remove using a 7/16 socket wrench. Slide out tube
channel assembly.
NOTE: Soak the bolts with penetrating oil for at least 15
minutes before trying to remove them.
Replacing Tube Channel Assembly
1. Slide one gasket onto each tube.
2. Slide the tube channel assembly into side of firebox
and insert each tube into the corresponding hole in the
tube channel rack starting with the back hole first.
3. Make sure tube channel assembly is flush against the
side of the appliance and secure with channel nuts.
4. Re-install channel cover and side shield.
NOTE: Service Space
In order to replace the tube channel assembly a
clearance of 19 inches (483mm) is required on the right
side of appliance in order to remove the tubes with the
appliance in place.
If space is not available, the appliance will have to be
disconnected from the chimney to proceed with the
tube replacement.
Channel
Access
Cover
Channel
Nuts (2)
Tube Channel
Assembly
7033-351D
Channel Cover
Screws (4)
Remove
2 Screws
Side Panel
September 9, 2019