Mazda Mazda3 2019 Owner's Manual page 279

▼ Shift-up/Shift-down Request Display
(Manual Transmission)
The shift-up or shift-down request display
might be displayed while the CTS is
operating. When this occurs, shift gears
because the gear position is not
appropriate.
Request
Shift up Shift Up to a Higher Gear
Shift down Shift Down to a Lower Gear
NOTE
If the gears are not shifted up even

though the shift-up request indication is
displayed, load will be applied to the
engine and the CTS might be
automatically cancelled or engine
damage could occur.
If the gears are not shifted down even

though the shift-down request indication
is displayed, the CTS might be
automatically cancelled or engine
stalling could occur.
▼ Stop Hold Control (Automatic
Transmission)
While in headway control using the CTS,
your vehicle will stop when a vehicle
ahead stops. When the vehicle is stopped
and the stop hold control operates, the
CTS indicator light turns on.
NOTE
If the CTS is temporarily cancelled

during stop hold control, the vehicle is
held in its stopped position.
Indication on display
i-ACTIVSENSE
The parking brake is automatically

applied and the vehicle is held in its
stopped position when 10 minutes or
longer have passed since the stop hold
control operated. When this occurs, the
CTS is temporarily cancelled.
If the i-stop operation conditions are

met during stop hold control, the engine
stops even though the brake pedal is not
depressed.
Refer to i-stop on page 4-11.
The brake lights turn on during stop

hold control.
To resume driving
After the vehicle ahead starts moving
while your vehicle is stopped under stop
hold control, press the RES switch or
depress the accelerator pedal to cancel the
stop hold control and start driving.
NOTE
When you resume driving by pressing

the RES switch, your vehicle does not
start moving until the distance between
your vehicle and the vehicle ahead
lengthens to the specified distance or
farther.
The engine restarts automatically when

any of the actions to resume driving are
performed while i-stop is operating.
If the CTS is temporarily cancelled

during stop hold control, you cannot
resume driving by pressing the RES
switch when there are no vehicles in
front of your vehicle. Depress the
accelerator pedal and resume driving
the vehicle.
When Driving
4-153