Selecting Com/Nav Frequencies - Garmin GTN 725 Pilot's Manual

1.7
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Standby Com
Com/Nav
Frequency
Com Standby
Editing Window
FPL
Find Frequency
Direct-To
Numeric Keypad
Proc
Standby Frequency
Monitor Key
Charts
Wpt Info
Map
Traffic
To switch between Com and Nav frequency selection
Tuning control normally remains in the Com window and will return after 30
Terrain
seconds of inactivity. If you wish to select a VOR/localizer/ILS frequency, press
the small right knob momentarily to make the Nav window active for editing.
Weather
The Standby Nav frequency will be highlighted briefly to indicate that it is active
for editing. The standby frequency in blue is active for editing by the large and
Nearest
small right knobs.
Services/
Music
Method 1: Select a Nav/Com frequency using the small and large right rotary knobs
Utilities
System
Messages
Symbols
Appendix
1-16
Index

Selecting Com/Nav Frequencies

Volume and
Squelch
Key
Figure 1-20 Com Radio Frequency Selection Page
1. Turn the large right knob to select the desired megahertz
(MHz) value. For example, the "118" portion of the frequency
"118.30".
2. Turn the small right knob to select the desired kilohertz
(kHz) value. For example, the ".30" portion of the frequency
"118.30".
3. Touch the Com or Nav window to flip/flop the Active and Standby
frequencies. You can also press and hold the small right knob
to transfer the standby frequency to the active window.
Active Com Frequency
Frequency Monitor
Annunciation
GTN 725/750 Pilot's Guide
Active Nav Frequency
Standby Nav Frequency
Standby
Frequency
Backspace
Key
Frequency
Transfer
(Flip/Flop)
Key
Large and
Small Knobs
(Frequency
Adjust)
Enter Key
190-01007-03 Rev. C