Charging The Battery Pack 電池包充電 3 - THUNDER TIGER Sparrowhawk XXT Instruction Manual

1
1.1 CHARGING THE BATTERY PACK 電池包充電
(Battery and Charger are not included in the kit.
a. Once the battery ready to be charged, first plug the AC quick charger into the outlet of AC power source, and then connect the
battery input/output harness to the charger.
b. Continued to monitor the battery as it is being charged. As soon as the battery is fully charged, disconnect the battery. from the
charger plug (Over-charging or charging incorrectly using inadequate chargers may cause the battery pack to become dangerously
hot).
c. Make sure that the battery pack is completely discharged prior to charging. Discharging the battery pack by running the electric
motor until it slows down or using a discharger (Not included).
d. For best results, let the battery pack cool before charging. Heat may prevent the battery pack from charging to full capacity and
also decreases the performance of the battery.
a. 準備充電時，首先將充電器之插頭插入電源插座，再連接電池之充/放電接頭。
b. 充電過程中請注意電池之充電情況。電池充電完成將電池與充電器接頭分開。(電池過充或是不適當之充電，將可能導致電池產生
危險之過熱情況，如電池溫度超過攝氏45度，需立即停止充電。）
c. 電池充電前，最好先確認電池是否已經完全放電。倘若尚未放電完全，可將車子加速直到馬達轉速變慢或使用專業放電器放電(另購)。
d. 為得到最佳之充電效果，電池使用完畢請勿馬上進行充電，充電前請先確認電池溫度已下降再行充電，以延長電池壽命及電池性能。
1
PLUG INTO AC OUTLET.
插入AC插座
1.2 LiPo BATTERIES 鋰電池充電注意事項
Lithium Polymer (LiPo) batteries are becoming popular for use in R/C models due to their compact size, high energy density, and
high-current output. However, these types of batteries require special care and handling procedures for long life and safe operation.
鋰電池（鋰聚合）因為其形狀的多變性，高電容量及高放電的特性，所以現今已是非常受歡迎的一種遙控模型電池種類。然而由於此
種電池具有相當程度的使用風險性，故在使用時「正確的使用」以延長持電池壽命與嚴守「操作安全」這兩點是需特別注意的。
Warning: Lithium Polymer (LiPo) batteries are intended only for advanced users that are educated on the risks associated
with LiPo battery use. THUNDER TIGER/ACE RC does not recommend that anyone under the age of 16 use or
handle LiPo battery packs without the supervision of a knowledgeable and responsible adult.
Important: Do not use NiCd/NiMH battery chargers for LiPO batteries. If you do not use a special charger for LiPO batteries,
they will be damaged.
警告：鋰電池（鋰聚合）的使用者需具備進階鋰電池使用知識並瞭解其中可能因未使用錯誤所引發的潛在危險。THUNDER TIGER/ACE
RC強烈建議使用者需年滿16歲或是經由具有鋰電池進階使用之是的成人陪同操作。
注意：請勿使用鎳氫/鎳鎘充電器對鋰電池進行充電！此舉很可能引起電池的損壞。請使用專業之鋰電池充電器進行鋰電池之充放電。
The ACE RC BLC electronic speed control is able to use LiPo batteries with nominal voltage not to exceed11.1 volts (3S packs).
Exceeding these voltages may result in damage to your brushless system. LiPo batteries have a minimum safe discharge voltage
threshold that should either not be exceeded. The ACE RC BLC electronic speed control is equipped with built-in Low-voltage detection
that cuts the power automatically when batteries have reached their minimum voltage (discharge) threshold. Refer to the low power
auto-cut table in the ESC instruction manual. It is the driver's responsibility to stop immediately to prevent the battery pack from being
discharged below its safe minimum threshold. It is critical for you, the user, to follow all other instructions supplied by the battery
manufacturer and the charger manufacturer for proper charging, use, and storage of LiPo batteries. Make sure you understand how
to use your LiPo batteries. Be aware that THUNDER TIGER/ACE RC shall not be liable for any special, indirect, incidental, or
consequential damages arising out of the installation and/or use of LiPo
batteries in THUNDER TIGER models.
ACE RC BLC系列之無刷馬達速控器在設計上是可以允許使用鋰電池，但須注意請勿使用超過11.1 volts (3S packs)的鋰電池，否則你
的無刷馬達速控器及無刷馬達很可能因過高的電壓而燒毀。使用鋰電本身應該也需具有過度放電之保護，以避免電電池本身的壽命及
效能產生不可回復性的傷害。ACE RC BLC系列之無刷馬達速控器本身內建有低電壓偵測裝置，當電池電壓低於一定電壓時速控器會
進行自動斷電程序以保護電池之壽命。請參考速控器說明書上低電壓斷電表。發生上述斷電情況請操作者即刻暫停操作以防止電池之
損壞。操控者在使用鋰電池時應先詳讀電池及充電器廠商所提供之使用操作說明書以瞭解正確的鋰電池充放電方法，儲存及使用方
式。請注意！THUNDER TIGER/ACE RC對於消費者因為使用或安裝鋰電池於所屬之遙控模型上而造成任何的直接或間接的損害，無
須擔負任何法律責任。
2
CONNECT BATTERY PLUG
TO DC OUTLET PLUG FROM CHARGER.
連接電池與充電器
本產品不含電池及充電器
3
AFTER CHARGE TIME EXPIRES,
DISCONNECT
BATTERY PLUG FROM CHARGER PLUG.
充飽電池後，將電池與充電器接頭分離
)