Preparing The Radio; Installing The Battery Pack; Radio Operation - THUNDER TIGER PHOENIX ST BX Manual

3

PREPARING THE RADIO

a a
a.
Install the antenna into transmitter.
b.
Check the frequency printed on the transmitter crystal.
c.
Check the frequency printed on the receiver crystal, and make sure it matches with the transmitter
crystal. Make sure no one will operate on the same frequency when you are. When there is a radio
glitch, it will most likely be caused by improper crystal, damaged crystal, or people operating on the
same frequency.
4

INSTALLING THE BATTERY PACK

a
a.
Install 8 AA-size alkaline batteries into transmitter.
b.
Install the power pack (Flat type battery pack shown in the picture) and connect to the ESC.
c.
Caution: Check all the wiring and connections before you connect the speed control to a drive battery.
Incorrect polarity will wreck your speed control.
5

RADIO OPERATION

a
a.
When turning radio on, first turn on the transmitter.
b.
Then, turn on the receiver. When turning off, first turn the receiver off, then the transmitter off.
c.
To reverse the functions of servos, use the small, white servo reverse switches located on side of the
pistol transmitter (or the inset servo reverse switches located at the bottom of the stick transmitter).
To trim the servos on pistol transmitter, use the trim switches on side of the steering wheel (the ST.
trims steering, and the TH trims throttle/brake). On a stick transmitter, the trim levers are located
accordingly around the sticks.
d.
Do not run flat the battery of your transmitter in case of losing control of the car.
e.
For more details, please check the transmitter instruction manual.
b
b
b
c
c
(Battery products are not included in kit)
c