Source Technologies STI MICR ST9335 ST9335 ST9335 User Manual page 41

Audit Report Field Four
&%SQ4
d..d
~
This command identifies the data to be printed in the fourth column of the report. It is a
maximum of 16 characters in length. Since a total of this field can be provided at the end
of the Audit Trail Report it is typically used for the convenience amount field. NOTE: This is
the only command where the $ is not a command terminator. The tilde ~ (hex 7E) acts as
the command terminator.
Audit Report Field Five
&%SQ5
d..d
$
This command identifies the data to be printed in the fifth column of the report. This field is
a maximum of eight characters.
Audit Report Field Six
&%SQ6
d..d
$
This command identifies the data to be printed in the sixth column of the report. This field
is a maximum of 19 characters.
Audit Report Field Seven
&SQ&7
d..d
$
This command identifies the data to be printed in the seventh column of the report. This
field is a maximum of 12 characters. The data in this field is recorded for the Audit Report
only.
Secure MICR Printer User's Guide
July 2003
&%SQ4d..d~
Lead in sequence
Data to be printed
Command terminator
&%SQ5d..d$
Lead in sequence
Data to be printed
Command terminator
&%SQ6d..d$
Lead in string
Data to be printed
Command terminator
&%SQ7d..d$
Lead in string
Data to be stored
Command terminator
Page 37
Section 8: Audit Trail Reports
©
Source Technologies
All rights reserved