Micr Mode Commands - Source Technologies STI MICR ST9335 ST9335 ST9335 User Manual

When entering MICR mode with the &%STH command, the printer will:
• Check to see if the proper Front Panel Combination has been entered (when
enabled).
• Allow access to secure check printing resources such as MICR fonts and secure
fonts which are stored in printer ROM. It also allows access to protected
signatures, overlays, logos and other important resources stored in password
protected nonvolatile flash memory.
• Turn Hex Transfer ON.
NOTE: The &%STH command can occur within a datastream after the page has
started. The &%STH command, unlike the &%STF command, can be issued
anywhere on the page.

MICR Mode Commands

Password Command
&%STF or &%STH
PASSWORD
$
MICR Definition Command
&%SMCP
xxxx
$
Example: &%SMCP0010$
Prints 16 (Hex 10) MICR lines before disabling MICR mode. This command defines how
many MICR lines may print in the current job. When the count decrements to zero, MICR mode
is terminated.
Set New Password Command &%STExxxxxxxx$
&%STE
xxxxxxxx
$
Secure MICR Printer User's Guide
July 2003
&%STFPASSWORD$ or &%STHPASSWORD$
Lead in sequence
User defined password, 8 characters, case sensitive,
unprintable characters allowed. Factory default is
PASSWORD. See also New Password Command.
Command terminator
&%SMCPxxxx$ (optional)
Lead in sequence
MICR count, the number of MICR lines to be printed during
this print job. (4 bytes in hex)
Command terminator
Lead in sequence
New password, must be 8 characters either printable or non
printable. Dollar ($) sign is an invalid password character.
Command terminator.
Page 20
Section 6: MICR Features
©
Source Technologies
All rights reserved