Table of Contents
Advertisement
3. Warm up the labyrinth sealing ring. Push the labyrinth sealing ring to approx. 3 mm before
4. Locate the labyrinth sealing ring in position by screwing the set screws in. Check that the
SIMOTICS TN Series N-compact 1LH8
Operating Instructions 06/2017
the bearing cover before the paint or adhesive cures on the set screws.
3 mm
Figure 9-5
Position the set screws for the labyrinth sealing ring on the outer bearing cover
tips of the set screws engage with the keyway with a short axial movement.
The correct axial position is obtained when the locating setscrews screwed into the keyway
engage.
Maintenance
9.2 Corrective Maintenance
111
Advertisement
Table of Contents
