Image 9-7 Position The Set Screws For The Labyrinth Sealing Ring On The Outer Bearing Cover - Siemens 1LA8 Operating Instructions Manual

Maintenance
9.2 Corrective Maintenance
3. Warm up the labyrinth sealing ring. Push the labyrinth sealing ring to approx. 3 mm before
4. Locate the labyrinth sealing ring in position by screwing the set screws in. Check that the
116
the bearing cover before the paint or adhesive cures on the set screws.
3 mm
Image 9-7 Position the set screws for the labyrinth sealing ring on the outer bearing cover
tips of the set screws engage with the keyway with a short axial movement.
The correct axial position is obtained when the locating setscrews screwed into the keyway
engage.
SIMOTICS TN Series N-compact 1LA8
Operating Instructions 05/2016