Access Point Mode - Viessmann VITOCONNECT OPTO2 Installation And Operating Instructions Manual

Communication interface for remote monitoring and remote control of heating systems over the internet, for the following user interfaces

Hide thumbs Also See for VITOCONNECT OPTO2:

Table of Contents

Operating

Access Point Mode

Vitoconnect OPTO2 Installation and Operating

In access point mode you can query open source

licences and configure the Wi-Fi router.

Activate the access point mode, e.g. after replacing the

Wi-Fi router.

Activating access point mode

Press the operating button A (see page 11) for longer

than 5 seconds, but not longer than 30 seconds.

LED illuminated in green: Access point mode is active.

Deactivating access point mode

1. Access point mode is automatically deactivated

after 5 min.

2. Again, press the operating button A (see page 11) for

longer than 5 seconds, but not longer than 30 seconds.

LED no longer illuminated. Access point mode is

deactivated.

Note: On commissioning, access point mode is activated

automatically as soon as you plug in the wall power

supply. Access point mode remains active until

commissioning of the Vitoconnect has completed.

There is no need to manually deactivate access

point mode.

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the VITOCONNECT OPTO2 and is the answer not in the manual?