Maintenance Mode; Setting Up The Wi-Fi After Replacing The Router; Software Update; Maintenance - Viessmann VITOCONNECT OPTO2 Installation And Operating Instructions Manual

Vitoconnect OPTO2 Installation and Operating

Maintenance Mode

Setting up Wi-Fi after Replacing the Router

Software Update

Maintenance

Cleaning

Operating button area
Operating button
Operating status LED
Communication LED
System function LED
Reset button
This function suppresses the transmission of messages
from the heating system to the Viessmann server,
e.g. during maintenance work on the heating system.
Activating maintenance mode
Press the Reset button for approx. 5 to 15 seconds:
LED pulsating in red.
Maintenance mode is activated.
Deactivating maintenance mode
1. Maintenance mode is automatically deactivated
after 8 hours.
or
2. Press the Reset button again for approx. 5 to 15 secs:
LED no longer illuminated.
Maintenance mode is deactivated.
1. Activate the Vitoconnect access point mode:
see page 20.
2. Open the Wi-Fi settings of your smartphone.
3. Connect your smartphone to the
"VITOCONNECT-<xxxx>" Wi-Fi.
4. Enter the WPA2 password.
Note: The WPA2 password can be found on the
supplied sticker.
5. Use the Internet browser on your smartphone to
access http://vitoconnect.gateway
6. On the starting page, select "Select router".
7. Follow the instructions on the Internet page.
8. Access point mode is automatically deactivated
after 5 min.
or
Manually deactivate the Vitoconnect access point
mode: see page 20.
Any available software updates will be automatically
downloaded. During the update, the LED
in green. This can last up to 5 minutes. Once the update is
complete, the Vitoconnect will restart.
The Vitoconnect is maintenance-free.
You can clean the surface of the appliance with a
microfibre cloth. Don't use any cleaning agents.
Maintenance
will be illuminated
17