Access Point Mode; Activating Access Point Mode; Deactivating Access Point Mode - Viessmann Vitoconnect 100 Operating Instructions For The System User
Communication interface for remote monitoring and control of heating systems via the internet, for the following user interfaces
Hide thumbs
Also See for Vitoconnect 100:
Table of Contents
Advertisement
Access point mode
In access point mode, open source licences can be
scanned and wireless router settings can be carried
out.
Activating access point mode
Press reset button
and hold down for longer than
A
5 seconds, but no longer than 30 seconds: See chap-
ter "Display and controls".
LED
pulsates yellow:
Access point mode is active.
Deactivating access point mode
1. Access point mode is deactivated automatically
after 5 minutes.
Or
2. Press reset button
A
ger than 5 seconds, but no longer than 30 sec-
onds: See chapter "Display and controls".
LED
is no longer illuminated.
Access point mode is deactivated.
again and hold down for lon-
Enable access point mode, e.g. after replacing the
wireless router.
Note
During commissioning, access point mode is enabled
automatically as soon as you plug in the plug-in power
supply unit. Access point mode remains active until
Vitoconnect commissioning is complete. Manual disa-
bling of access point mode is not required.
Control functions
15
Hide quick links:
Advertisement
Table of Contents
