Table of Contents
Advertisement
Quick Start Guide: LPC435x-Xplorer++
3.3.9 USB0_HOST
Test setup and verification:
Connect the USB AM to Micro cable to USB1 on board connector and PC and Flash the Usb0Msc
binary and RESET the board. Open Hyper-Terminal and select Vcom port with 9600Mbps, insert the
2 GB pen drive to on board host connector, the content of first sector is displayed on Hyper-Terminal as
shown in the following image.
Fig.31
26
www.ngxtechnologies.com
Advertisement
Table of Contents
Need help?
Do you have a question about the LPC435x-Xplorer++ and is the answer not in the manual?