Table of Contents
Advertisement
Quick Start Guide: LPC435x-Xplorer++
3.3.3 Test LEDs
Test setup and verification:
To test LEDs, enter option 1, the LED4 and LED5 on board starts blinking.
3.3.4 Micro SD connector
Test setup and verification:
To test SDIO enter option 7, the firmware validates the micro SD card interface by writing and reading a
sector of the SD card connected. Please note that we need to use a micro SD card with FAT file system.
The result of this test is displayed over the VCOM port.
22
Fig.23
Fig.24
www.ngxtechnologies.com
Advertisement
Table of Contents
Need help?
Do you have a question about the LPC435x-Xplorer++ and is the answer not in the manual?