Threading The Quilting Machine - Brother Dream Quilter 15 Instruction Manual

1. Place thread on the cone style thread stand.
2. Pull the thread through both loops of the thread mast.
3. Put the thread through the top hole on the thread
guide, wrap the thread around and through the bottom
hole of thread guide at the middle of the machine.
4. Take the thread through the first thread tensioner,
between the two disks.
5. Loop the thread down around the second tensioner.
6. Pull the thread through the tensioner disks and around
the Check Spring.
7. Feed the thread into the thread guide below the
tensioner
8. Feed the thread through the right thread guide up to
the take up lever.
9. Pull the thread through the hole in the take up lever.
10. Feed thread into the left thread guide below.
11. Pull the thread down towards the needle and
through the bottom thread guide.
12. Feed the thread through the eyelet in the
front of the needle arm.
13. Feed the thread through the eye of the
needle.
9
10 8
5
6
7
11
12
13

Threading the Quilting Machine

3
4
12
13
Front View
Groove
Make sure the
thread is between
the tensioner discs.
Use cone
style thread
The Thread Must
Go Through The
Check Spring.
*Be sure to
install the
Needle with
the scarf
toward
the throat
of your
machine.
11
Needle Diagram
Side View
Shank
Shaft
Eye
Point
1
Scarf
2