Flat Head Screw Driver
1. Place your needle plate on your sewing machine and rotate hand wheel to ensure needle plate ori-
entation so that all screw holes are visible and needle enters the middle of the needle plate without
contacting the needle plate at any point.
2. Attach your needle plate using 4 needle plate screws, don't tighten the screws during this step.
3. Rotate hand wheel until the needle is in the lowest position move needle plate till it is centered
around needle and tighten all 4 needle plate screws.
Note: The Needle Plate can be removed for cleaning the hook assembly, checking timing of the Hook
Assembly and for removing tangled thread.
The Needle Plate
Needle Plate Screw