Connect wiring
Step
1
See Figure 3-9. Open the transmitter's rear end cap (opposite end from display).
2
Open the cable gland (on right side below antenna). (Cable gland must be ordered as an
option.)
3
Feed probe wiring through the cable gland and connect to terminal block. See Figure 3-9. For
terminal connections see info starting on page 55.
4
Plug battery connector into batteries.
5
Close rear end cap and cable gland.
Revision 12
February 2013
Figure 3-9 Corrosion transmitter with remote probe
OneWireless XYR 6000 Transmitters Quick Start Guide
Action
Process Insertion
Corrosion models
37