LAI Games HYPERshoot Operator's Manual page 30

Error Rear Sensor
Error EEP Audit UR
Error EEP Audit R
Error PSet
30
The rear sensor has been
reported as active for too long
The CPU cannot read or write
to its on-board EEPROM
unresettable audits, or is
receiving errors during
communication with the
EEPROM.
The CPU cannot read or write
to its on-board EEPROM
resettable audits, or is
receiving errors during
communication with the
EEPROM.
The CPU cannot read or write
to its on-board EEPROM
program settings, or is
receiving errors during
communication with the
EEPROM.
Check that the sensor is not dirty or
blocked by anything.
Use the operator menu input tests to
check that the Rear Sensor input is
triggered when throwing a ball.
Check that the sensor is connected
correctly.
If the problem persists, you may need
to recalibrate the sensor. Instructions
for this can be found in the operator
manual.
Set all audits to default by viewing
the error in the errors menu and
pressing the right button.
If the error still occurs, the IC is faulty
and needs to be replaced.
Set all audits to default by viewing
the error in the errors menu and
pressing the right button.
Set resettable audits back to default
by going into the audits menu and
press and hold the right button. If the
error still occurs, the IC is faulty and
needs to be replaced.
Clear the error by viewing it in the
errors menu and pressing the right
button.
If the error still occurs, the IC is faulty
and needs to be replaced.