Volvo S80 Owner's Manual page 232

Jack attachment points
6. There are two jack attachment points on
each side of the vehicle. Position the
jack correctly in the attachment (see
illustration above) and crank while si-
multaneously guiding the base of the
jack to the ground. The base of the jack
must be flat on a level, firm, non-slip-
pery surface. Before raising the vehicle,
check that the jack is still correctly
positioned in the attachment.
7. Raise the vehicle until the wheel to be
changed is lifted off the ground.
8. Unscrew the wheel nuts completely and
carefully remove the wheel so as not to
damage the threads on the studs.
06 Maintenance and specifications
9. Raise the vehicle until the wheel to be
changed is lifted off the ground.
10.Unscrew the wheel nuts completely and
carefully remove the wheel so as not to
damage the threads on the studs.
WARNING
• The jack must correctly engage the jack
attachment.
• Be sure the jack is on a firm, level, non-
slippery surface.
• Never allow any part of your body to be
extended under a vehicle supported by a
jack.
• Use the jack intended for the vehicle
when changing a tire. For any other job, use
stands to support the vehicle.
• Apply the parking brake and put the gear
selector in the Park ( P ) position.
• Block the wheels standing on the ground,
use rigid wooden blocks or large stones.
• The jack should be kept well-greased.
Re-installing the wheel
1. Clean the contact surfaces on the wheel
and hub.
2. Lift the wheel and place it on the hub.
Wheels and tires
Tighten the lug nuts
3. Install the wheel nuts and tighten hand-
tight. Using the lug wrench, tighten
crosswise until all nuts are snug.
4. Lower the vehicle to the ground and
alternately tighten the bolts crosswise
to 62 ft. lbs. (85 Nm).
5. Install the wheel cap (where applicable).
06
231