Volvo S80 Owner's Manual page 104

you to do this procedure a third time to
complete the training.)
The garage door opener should now recog-
nize the HomeLink Wireless Control System.
The remaining two buttons may now be
trained if this has not previously been done.
Refer to the Programming portion of this text.
The HomeLink Wireless Control System
(once programmed) or the original handheld
transmitter may be used to activate the
garage door. In the event that there are still
difficulties in programming the HomeLink
Wireless Control System, please visit our
Web site, www.homelink.com.
Reprogramming a Single HomeLink
Button
To program a device to HomeLink using a
HomeLink button previously trained, follow
these steps:
1. Press and hold the desired HomeLink
button. Do NOT release until step 4 has
been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
handheld transmitter 1 to 3 inches away
from the HomeLink surface.
3. Press and hold the handheld transmitter
button. The HomeLink indicator light will
flash, first slowly and then rapidly.
4. When the indicator light begins to flash
rapidly, release both buttons.
The previous device has now been erased
and the new device can be activated by
pushing the HomeLink button that has just
been programmed. This procedure will not
affect any other programmed HomeLink.
Erasing Channels
Individual buttons cannot be erased. How-
ever, to erase all three programmed buttons:
1. Press and hold the two outside buttons
until the indicator light begins to flash
(after 20 seconds).
2. Release both buttons.
The HomeLink® Wireless Control System is
now in the training (learning) mode and can
be programmed at any time following steps 2
through 4 in the Programming section.
03 Your driving environment
HomeLink® Universal Transceiver (option)
03
103