Global LP 8970 I Series Manual page 119

(3). Power cord:
a. Avoid power cord being applied by heavy objects or excessive force, or over bend.
b. Power cord must not set to be near the V-belt and the pulley, keep 3 cm space or above.
c. Check the outlet voltage before plugging the cord, make sure it match the voltage shown on the name
plate of the Feeder in ±10 % ranges.
Attention : If the control box is AC 220V system, please don't connect to the
(4). Grounding:
a.
To avoid the static interference and current leakage, all grounding must be done.
b.
Use the correct connector and extension wire when connecting ground wire to Earth and secure it
tightly.
1.3 Safety In Operating :
(1). When turn on the machine in the first time, use low speed to operate and check the correct rotation
direction.
(2).
During machine operation, don't touch any moving parts.
(3). All moving parts must use the protective device to avoid the body contact and objects insertion.
AC 380V power outlet. If that happened, please turn off the power
switch immediately and check the power voltage. Continue supply
the 380V power over 5 minutes might damage the fuses (F1,F2) and
burst the electrolytic capacitors (C3,C4) of the main board and
even might endanger the person safety.
Brown wire
Blue wire
Green/Yellow
Grounding
2
Ground Wire (Green/Yellow) must be grounding.
Properly current leakage cause uncomfortable
Even hurt the body if not grounding.