Section 4 Using The Hmi; Using The Local Hmi; Logging On - ABB Relion 630 Series Operation Manual

1MRS757183 F
Section 4
4.1
4.1.1
PML630/Compact Load-Shedding Solution
Operation Manual
Using the HMI

Using the local HMI

At delivery, logging on is not required and the user has full access until users and
passwords are created with PCM600 and written into the IED.
Commands, changing parameter values and resetting indications, for example, are
actions requiring password when the password protection is activated. Reading
information on the LHMI is always allowed without password.
HMI operations are possible only for authorized users.
Do not switch off the auxiliary power supply to the IED before
changes, for example, setting parameter or local/remote control state
changes are saved.
A mechanism for limiting the number of writings per time period is included in the
IED to prevent the flash memory from wearing out due to too many writings caused
by the application configuration. As a consequence, saving application function states
may take up to an hour. If the auxiliary power is interrupted before the states are saved,
that change is lost. Settings and configuration parameters are saved without delay.

Logging on

1.
Press to activate the logon procedure.
The logon is also activated when attempting a password-protected operation.
2. Select the user name from the list.
GUID-95803B3F-E963-4312-9E1F-0642B9A6ABD5 V1 EN
Figure 13: Selecting the user name
3. Enter the password when prompted digit by digit and select OK.
Section 4
Using the HMI
33