Changing System Network Settings - HP ProLiant 300 Series Administration Manual

was utilized to initiate the request. For example, a restart initiated using the WebUI generates an e-mail
message indicating a restart has occurred. Initiating a restart using the Windows Storage Server 2003
schedule or Desktop will not. Messaging in the status bar and page is limited to the following areas:
• WebUI Alerts
• NTBackup backup started
• NTBackup restore started
• Defrag started
• UPS power failure
• Restart pending
• Shutdown pending
• DFS not configured
• Date and time not configured
• No certificate
• Quota management alerts
• Event Log Messages
• NTBackup Information
• UPS power failed
• UPS power restored
• UPS invalid config
• UPS system shutdown
• Quota management alerts
To activate this option:
1. From the WebUI, click Maintenance. Then click Alert E-mail. The Set Alert E-Mail
page is displayed.
2. Select Enable Alert E-mail.
3. Indicate the types of messages to be sent.
• Critical alerts
• Warning alerts
• Informational alerts
4. Enter the desired e-mail address in the appropriate boxes.
5. After all settings have been entered, click OK.

Changing system network settings

Network properties are entered and managed from the Network tab. Most of these settings are
entered as part of the Rapid Startup process. Settings made from this tab include adding the storage
server to a domain.
Online help is available for these settings.
28 Basic Administrative Procedures and Setup Completion
Figure 7 is an illustration of the Network tab.