Setting Permissions For An Smb File Share; Creating A File Share Resource - HP ProLiant 300 Series Administration Manual

Figure 99 Creating a file share resource
5. Click Next.
6. Select the possible owners, and then click Next to continue.
7. Specify the dependencies for the file share resource. The physical disk should always be selected
as a dependency. It is also possible to set the file share to be dependent on the network name for
the cluster group in which it will reside. If a dependency is set on the network name the file share
resource will not come online until the network name resource does. Click Next to continue.
NOTE:
The physical disk resource specified in this step must reside in the same cluster group as specified in
the beginning of this wizard.
8. Specify the share name, path, and user limit, and then click Next to continue.
9. Review the configuration, and then click Finish to create the share.
10. After the resource is created it is necessary to bring it online. In the Cluster Resources page, select
the resource, and then click Bring Online.
11. Click OK on the Bring a Resource Online page to bring the new file share resource online.

Setting permissions for an SMB file share

When a share resource is created via the WebUI and brought online, the default permission is set to:
Everyone=Read-Only.
To change the default permissions:
1. On the Cluster tab, click Advanced Cluster Management.
2. Log into Remote Desktop.
3. Click the group.
194 Cluster Administration