Assembling Your Scooter Following Transportation - Rascal Frontier Owners Manual & Service Record

To transport your scooter you may need to remove the seat lower and the tiller in order to reduce the overall
height. You are advised to wear gloves during this operation .
1. Lift off the front basket.
2. Remove the seat by lifting it off the seat post while lifting the seat lever (Fig.13). A small rotation is
sometimes necessary to free the seat. Warning, the seat is heavy and two persons may be needed.
3. Lower the tiller to its horizontal position and lock using the tiller locking lever (Fig.14 & 15).
4. Secure the tiller with a strap to prevent the tiller moving.
5. Make sure that the ramps are secure.
6. Drive the scooter up the ramps and into the vehicle.
7. Ensure that all parts are secure so that they cannot move while driving.
13
Warning!
Only use ramps to position the scooter into the back of a vehicle. Do not try and lift it - back
injury may result!

Assembling your Scooter following Transportation

Warning!
Assembling the scooter involves lifting and handling heavy parts. Your dealer should advise you
on the best way to assemble your scooter.
Warning!
Pinching or Crushing. Be careful to avoid being pinched or having your hands crushed when
lifting or handling parts. Wear gloves whenever possible.
Warning!
Never unload your scooter on sloping or uneven ground. It could run down the slope and
injure someone.
Unload your scooter from the vehicle, using ramps and position it on level ground. Check it is undamaged
before starting to assemble it as follows:
1. Operate the tiller unlocking lever by pushing it down towards the tiller base (Fig.17). The tiller is now
free to be raised to the upright position. Re-lock the tiller by pulling the lever upwards.
14 15
15