Table of Contents
Advertisement
1. Click the Static Routes tab.
2. Click the Create New button.
3. Configure the following interface settings:
a) Network Address: Enter the destination IP address of this route.
b) Subnet Mask: Enter a subnet mask for the IP address above.
c) Gateway: Enter the IP address of the gateway router.
d) Interface: Select the physical interface to use for this route.
e) Metric: This represents the number of routers between the network and the destination.
4. Click Save.
5. Click Apply to save your changes.
You have completed configuring a static route.
Figure 116: The Static Route tab
Configuring a Data Plane
By default, the controller sends traffic from its data plane from a single interface. If your
organization's network requires separation of the access and core traffic, configure access and
core separation on the controller.
Follow these steps to configure the interface settings of a data plane.
1. Go to Configuration > System.
2. On the side menu, click Cluster Planes.
The Cluster Planes page appears.
3. Scroll down to the Data Planes section, and then click the name of the data plane that you
want to configure.
The Edit Data Plane Network Settings [{node name}] form appears.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
Configuring the System Settings
Configuring Cluster Planes
226
Advertisement
Table of Contents
