Viewing The Graceful Type-1 Check Status; Viewing A Global Type-1 Inconsistency - Cisco Nexus 3548 Configuration Manual

Viewing the Graceful Type-1 Check Status

Command
switch# show port-channel capacity
switch# show running-config vpc
switch# show vpc brief
switch# show vpc
consistency-parameters
switch# show vpc peer-keepalive
switch# show vpc role
switch# show vpc statistics
For information about the switch output, see the Command Reference for your Cisco Nexus Series switch.
Viewing the Graceful Type-1 Check Status
This example shows how to display the current status of the graceful Type-1 consistency check:
switch# show vpc brief
Legend:
vPC domain id
Peer status
vPC keep-alive status
Configuration consistency status: success
Per-vlan consistency status
Type-2 consistency status
vPC role
Number of vPCs configured
Peer Gateway
Dual-active excluded VLANs
Graceful Consistency Check
vPC Peer-link status
---------------------------------------------------------------------
id
--
1

Viewing a Global Type-1 Inconsistency

When a global Type-1 inconsistency occurs, the vPCs on the secondary switch are brought down. The following
example shows this type of inconsistency when there is a spanning-tree mode mismatch.
Cisco Nexus 3548 Switch NX-OS Interfaces Configuration Guide, Release 9x
68
(*) - local vPC is down, forwarding via vPC peer-link
Port Status Active vlans
---- ------ --------------------------------------------------
Po1 up 1
Purpose
Displays how many EtherChannels are configured and how many
are still available on the switch.
Displays running configuration information for vPCs.
Displays brief information on the vPCs.
Displays the status of those parameters that must be consistent
across all vPC interfaces.
Displays information on the peer-keepalive messages.
Displays the peer status, the role of the local switch, the vPC
system MAC address and system priority, and the MAC address
and priority for the local vPC switch.
Displays statistics on the vPCs.
This command displays the vPC statistics only for the
Note
vPC peer device that you are working on.
: 10
: peer adjacency formed ok
: peer is alive
: success
: success
: secondary
: 34
: Disabled
: -
: Enabled
Configuring Virtual Port Channels