Control Panel Keys; Remote Control - Tesla 49K309BF Operating Instruction

CONTROL PANEL KEYS

REMOTE CONTROL

Remote control battery installation method
Remove the battery compartment cover and insert two AAA (No. 7, 1.5V) batteries; make sure the polarity of the
batteries is in compliance with the polarity mark ''+'' and ''-'' in the battery compartment of the remote control.
Precautions for use of remote control
• The remote control should be pointed at the remote control sensor during operation. An object placed between the
remote control and the remote control sensor may impede normal operation.
• The remote control should be prevented from strenuous vibration. Besides, please do not set or place the remote
control under direct sunshine, as heating power may result in deformation of the remote control.
• Remote control failure may occur when the remote control sensor of the main unit is under direct sunshine or strong
lighting; in this case, please change the angle of lighting or this TV set, or operate the remote control near the remote
control sensor.
• Low battery will influence the remote control distance, in which case, the battery should be replaced with a new one. If
the remote control is going to be idle for a long time or the battery runs out, please take the battery out to prevent the
remote control from being corroded by battery leakage which may result in damage and failure of the remote control.
• Please do not use batteries of different types. It is not allowed to use old and new batteries together; the batteries
should be replaced in pair.
• Please do not throw the batteries into fire or charge or decompose the batteries; do not charge, short-circuit,
disassemble/assemble, heat or burn used batteries. Please dispose the waste batteries pursuant to relevant
regulations on environmental protection.
1. Power LED indicator and remote receiving window.
(SOURCE): Press this key to enter the menu to select
2.
signal source; during OSD menu operations, press this
key to confirm the operation, with the same function as
the [OK] key on the remote control.
3. – CH + (CH-/CH+): Channel down/up key; during OSD
menu operation, press the keys to select items, with the
same function as the / key on the remote control.
4. (VOL-/VOL+): Volume down/up key; during
OSD menu operation, press the keys to adjust the analog
value, with the same function as the t/u key on the
remote control.
5. (MENU): Press this key to show the setup menu.
6. Standby: To switch the TV on or back to standby.
Remark: Different models may have different appearances;
please refer to the actual device.
7
ENG