Controls - Toro Workman 07040 Operator's Manual

Controls

Become familiar with all the controls before you start the engine and operate the machine.
Note:
Determine the left and right sides of the machine from the normal operating position.
Control Panel
1. Steering wheel
2. Gear-shift indicator
3. Gear-shift lever
4. Horn button (International models only)
5. Key switch
Accelerator Pedal
Use the accelerator pedal
ground speed of the machine. Pressing down the
accelerator pedal starts the engine. Pressing the
pedal farther increases the ground speed. Releasing
the pedal slows the machine, and the engine shuts off.
Note:
The maximum forward speed is 26 km/h
(16 mph).
Brake Pedal
Use the brake pedal to stop or slow the machine
(Figure 6).
(Figure 6) to vary the
Figure 6
6. USB power point
7. Parking-brake lever
8. Choke control
9. Brake pedal
10. Accelerator pedal
CAUTION
Operating a machine with worn or incorrectly
adjusted brakes can may result in personal
injury.
If the brake pedal travels to within 25 mm (1
inch) of the machine floor board, adjust or
repair the brakes.
12
g033921