Sony SLV-SF99EN Operating Instructions Manual page 18

Getting Started
Step 4 : Tuning your TV to the VCR (continued)
5
6
7
RF
CHANNEL
To check if the TV tuning is correct
Set the TV to the video channel and press PROGRAM +/– on the VCR. If the TV
screen changes to a different programme each time you press PROGRAM +/–, the
TV tuning is correct.
To obtain a clear picture from the VCR
If the picture does not appear clearly in step 6 above, go to step 7 to finish this
procedure once. Then start from step 2. After pressing RF CHANNEL in step 2 to
display the RF CHANNEL, press PROGRAM +/–, so that another RF channel
appears.Then tune the TV to the new RF channel until a clear picture appears.
Notes
• When you connect the VCR and your TV only with an aerial cable, you have to set RF
MODULATOR in the OTHER OPTIONS menu to ON (see page 73).
• If you set the wrong TV system, you may have no sound or may be distorted.
18
Tuning your TV to the VCR
Press PROGRAM +/– (repeatedly) to select the correct TV system.
If you watch the system B/G, select "G". If you watch the system D/K,
select "K".
Tune the TV to the same channel as the one
shown in the display window so that the
picture on the right appears clearly on the
TV screen.
Refer to your TV manual for tuning
instructions.
If the picture does not appear clearly, see
"To obtain a clear picture from the VCR"
below.
Press RF CHANNEL.
You have now tuned your TV to the VCR. From now on, whenever you
want to play a tape, set the TV to the video channel.
AUTO SET UP SMARTLINK SP
LP
OPC
VPS
PDC
H
EDIT
EP STEREO
VIDEO TV NICAM
M S
SONY VIDEO CASSETTE
RECORDER