Assembly; Attach Stabilizers To Main Frame; Install Console Mast, Mast Gasket And Top Shroud On Main Assembly - Schwinn 170 Assembly Manual / Owner's Manual

ASSEMBLY

1. Attach Stabilizers to Main Frame

Note: Hardware(*) is pre-installed on the stabilizers and not on Hardware Card. Make sure transport wheels on the
front stabilizer point forward, and the Schwinn
X2
*
*
*

2. Install Console Mast, Mast Gasket and Top Shroud on Main Assembly

NOTICE: Make sure the Console Cable connector (a) does not fall into the Console Mast. Align the clips on the cable
connectors and make sure the connectors lock. Do not crimp Console Cable. Be sure the tabs on the Top
Shroud snap into the Main Assembly.
8
6 mm
decal on the rear stabilizer faces outward from the machine.
®
a
6
5
4
6 mm
X2
*
*
*
X4
6 mm
C
B
A