Trip Listing; Table 11-2. Trip Listing - Emerson Vilter PLC Operation Manual

Section 11 • Alarms, Trips, Status Information & Troubleshooting

Trip Listing

Blower will shutdown if active.
Trip Message
(T001) Trip: MCR Not Energized/E-
Stop Active
(T002) Trip: PLC to Central Comms
Faulted
(T003) Trip:
(T004) Trip: Setpoint out of Range -
See Menu Screen
(T005) Trip: Invalid Blower
Confi guration
(T006) Trip:
(T007) Trip: Faulted I/O Module
Connection or Module Type
(T008) Trip:
(T009) Trip:
(T010) Trip: Low Suction Header
Pressure
(T011) Trip: High Discharge Header
Pressure
(T012) Trip:
(T013) Trip:
(T014) Trip:
(T015) Trip: User Defi ned Trip 1
(T016) Trip: User Defi ned Trip 2
(T017) Trip: User Defi ned Trip 3
(T018) Trip: User Defi ned Trip 4
(T019) Trip: User Defi ned Trip 5
(T020) Trip: Blower 1 - High
Discharge Temperature
Blower Package PLC Operation Manual •Vilter/Emerson • 35391BLP

Table 11-2. Trip Listing

Cause(s)
Emergency Stop Button on PLC Panel
Pressed, Loss of Power, External
Emergency Stop Device Tripped
Loss of Communication with DCS/
Central - Settable Communications
Watchdog Timer Expired. (Action on
Comm Failure = Trip)
Blower Confi guration or Suction/
Discharge Pressure Source is invalid.
See Blower Confi guration Screen.
Suction Header Pressure drops
below "Suction Pressure" Low Trip
Setpoint
Suction Header Pressure rises above
"Discharge Pressure" High Trip
Setpoint
User defi ned Trip 1
User defi ned Trip 2
User defi ned Trip 3
User defi ned Trip 4
User defi ned Trip 5
Blower 1 Discharge Temperature
exceeds "Discharge Temperature"
High Trip Setpoint
Notes
Watchdog Active if Control by
Communications is selected
Active if monitoring Suction Header
Pressure
Active if monitoring Discharge
Header Pressure
Message Defi ned in "Device Names"
Screens
Message Defi ned in "Device Names"
Screens
Message Defi ned in "Device Names"
Screens
Message Defi ned in "Device Names"
Screens
Message Defi ned in "Device Names"
Screens
11 – 9