ICP DAS USA LinPAC-51 Series Quick Start Manual page 3

Connecting the LP-51xx to a Windows PC
The RS-232 connector is a standard non-isolated serial port (COM1 -
TxD, RxD, GND), and is located on the upper right-hand corner on the
LP-51xx module.
Connect the LP-51xx console to the COM port on the Host PC. Note that
it is unnecessary to connect to a converter.
Open HyperTerminal by clicking the Start button, point to All Programs,
point to Accessories, point to Communications, and the click Hyper
Terminal.
In the 'Port Setting' dialog box, set the parameters for COM 1 to 115200
bps, 8 data bits, no parity, 1 stop bit and no flow control, and then
press the OK button to save the settings.
ICP DAS LinPAC-51xx Quick Start
- 3 -